Basler raL2048-48gm Manuel d'utilisateur télécharger pdf (Page 41)

AW00118302000 Basler Network Drivers and Parameters

Basler racer GigE 31

Maximum Number Resend Requests - The Maximum Number Resend Requests parameter sets

the maximum number of resend requests the performance driver will send to the camera for each

missing packet.

Resend Timeout - The Resend Timeout parameter defines how long (in milliseconds) the

performance driver will wait after detecting that a packet is missing before sending a resend request

to the camera. The parameter applies only once to each missing packet after the packet was

detected as missing.

Resend Request Response Timeout - The Resend Request Response Timeout parameter

defines how long (in milliseconds) the performance driver will wait after sending a resend request

to the camera before considering the resend request as lost.

If a resend request for a missing packet is considered lost and if the maximum number of resend

requests as set by the Maximum Number Resend Requests parameter has not yet been reached,

another resend request will be sent. In this case, the parameter defines the time separation

between consecutive resend requests for a missing packet.

Packet Timeout - The Packet Timeout parameter defines how long (in milliseconds) the

performance driver will wait for the next expected packet before it sends a resend request to the

camera. This parameter ensures that resend requests are sent for missing packets near to the end

of a frame. In the event of a major interruption in the stream of packets, the parameter will also

ensure that resend requests are sent for missing packets that were detected to be missing

immediately before the interruption. Make sure the Packet Timeout parameter is set to a longer time

interval than the time interval set for the inter-packet delay.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 237 238

Pas de commentaire

Basler raL2048-48gm Manuel d'utilisateur Page 41