Basler BIP2-DXXXXc-dn Guide d'installation télécharger pdf (Page 11)

AW00101404000 Installation Guide

Basler IP Fixed Dome Cameras 9

EnglishLanguageLanguageLanguageLanguageLanguageLanguageLanguage

6. Mount the camera base on the wall or ceiling by placing three screws

through the mounting holes in the camera base and into the anchors as

shown in the drawing on the next page.

If you are installing an outdoor dome camera, be sure that each screw has

an O-ring as shown in the drawing and be sure to place the weather-proof

gasket between the camera base and the wall or ceiling as shown in the

drawing. The O-rings and the gasket are included in the outdoor dome

installation kit. (The O-rings and the gasket are not required for indoor dome

cameras.)

If you are routing the camera cables through the hole in the back of the

camera base, pull approximately 15 cm (6 inches) of cable through the hole

and into the camera base before you mount it.

When you are finished mounting the camera base,

a. Go on to Section 2.2 if you are working with an outdoor dome camera

and you want to route cables through the hole in the side of the camera

base.

b. Go on to Section 2.3 if you routed the camera cables through the back

of the camera base.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 88 89

Commentaires sur ces manuels

Pas de commentaire