Basler BIP2-DXXXXc-dn Guide d'installation télécharger pdf (Page 43)

AW00101404000 Installation Guide

Basler IP Fixed Dome Cameras 41

EnglishLanguageLanguageLanguageLanguageLanguageLanguageLanguage

8 The RS-485 Terminal Block

The 3-hole terminal block on the right side of the camera base can be used to

make an RS-485 connection to the camera.

The assignments for the wire fixing holes in the terminal block are as shown

below. The A+, B-, and Gnd connections are standard for an RS-485

connection. The RS-485 ground is isolated from the camera’s power ground

and I/O ground.

Fig. 5: RS-485 Terminal Block

The terminal block is a push-in type of connector. Either solid or stranded wires

can be inserted into the wire fixing holes in the terminal block. A wire can be

removed from a fixing hole by pressing the release tab above the hole and

pulling on the wire.

Wires inserted into the fixing holes must have a minimum cross section of 0.2

mm

2

(AWG 24) and a maximum cross section of 1.5 mm

2

(AWG 16).

8 mm (5/16") of insulation should be stripped from the end of a wire before it

is inserted into a fixing hole.

Wire

Fixing

Holes

Release

Tabs

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 88 89

Commentaires sur ces manuels

Pas de commentaire