Basler BIP2-DXXXXc-dn Guide d'installation télécharger pdf (Page 41)

AW00101404000 Installation Guide

Basler IP Fixed Dome Cameras 39

EnglishLanguageLanguageLanguageLanguageLanguageLanguageLanguage

Hole Name: DC Out

Function: DC Out supplies unregulated +5.6 VDC and can be used to power a small

device such as a relay. For example, the relay shown in the schematic drawing on

page 40 could be connected to DC Out rather than to an external source of power.

The maximum allowed load on DC Out is 50 mA.

If an inductive load such as a relay is used with DC Out, a diode must be connected

in parallel with the load as shown in the schematic page 40.

By default, I/O port 0 is set as an output with its function set to user

settable and I/O port 1 is set as an input with its function set to

monitor. The explanations in Table 1 and the schematic on page 40

assume that you have changed the port settings.

We recommend that I/O connections be made with shielded cable

and that the cable shields be connected to ground. If you are unable

to connect the cable shields to ground or if you use unshielded

cable, we recommend that you install a ferrite bead near to the

camera on each cable to minimize electromagnetic interference.

Table 1: Main Terminal Block Wire Fixing Hole Assignments

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 88 89

Commentaires sur ces manuels

Pas de commentaire