Basler BIP2-DXXXXc-dn Guide d'installation télécharger pdf (Page 19)

AW00101404000 Installation Guide

Basler IP Fixed Dome Cameras 17

EnglishLanguageLanguageLanguageLanguageLanguageLanguageLanguage

3. Complete the wiring at the terminal blocks.

a. If you will be using the camera’s I/O ports or the DC Out capabilities,

refer to Table 1 on page 36 and to Figure 4 on page 40, and make the

appropriate wiring connections at the main terminal block now.

b. If you are installing an outdoor dome camera and you want to disable

the camera’s heater (this will lower the camera power consumption),

refer to Table 1 on page 36 and apply a jumper between the "Heater

Off" and the "Gnd" wire fixing holes in the main terminal block now.

c. If you will be making an RS-485 connection to the camera, refer to

page 40 and make the appropriate wiring connections to the RS-485

terminal block now.

4. Connect the network cable to the RJ-45 connector now. It is easiest to

connect the cable if you loop it as shown below.

Looped

Network

Cable

RJ-45

Connector

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 88 89

Commentaires sur ces manuels

Pas de commentaire