Basler BIP2-DXXXXc-dn Guide d'installation télécharger pdf (Page 39)

AW00101404000 Installation Guide

Basler IP Fixed Dome Cameras 37

EnglishLanguageLanguageLanguageLanguageLanguageLanguageLanguage

Hole Name: I/O-0, I/O-1

Function: I/O port 0 and I/O port 1 respectively. Each I/O port can be set to operate

either as an input or as an output. The choice of whether a particular I/O port will

operate as an input or an output and how it will function is made by setting camera

parameters (see the camera user’s manual for details about setting camera

parameters).

For an I/O port set as an input:

In the schematic drawing on page 40, I/O-0 has been set to operate as an input.

Normally, you will connect an input port to I/O ground via a switch as illustrated in the

schematic.

As indicated in the table below, an input port will be detected by the camera as active

or inactive depending on whether the switch is open or closed and whether the port

is or is not set to invert.

See the camera user’s manual for more information about setting a port to invert.

Switch Condition Port Set To Invert Input Detected As

Open No Inactive

Closed No Active

Open Yes Active

Closed Yes Inactive

(I/O-0, I/O-1 description continued on the next page.)

Table 1: Main Terminal Block Wire Fixing Hole Assignments

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 88 89

Commentaires sur ces manuels

Pas de commentaire